MDM - engine protection / COMPATROL 2.0

By launching COMPATROL® technology, Weber MT broke new ground in the engineering
of surface covering compaction control for hand-guided soil compactors. Constantly
striving to elevate the quality and efficiency of their machines to ever higher level s,
Weber MT’s investment in research and development is above average.
The latest fruit of these investments: COMPATROL® 2.0 – the expansi on of the compaction
control by the active engine protection system MDM, available for soil compactor of the
CR 6 to CR 9 series. These models will be available in three versions: the standard version
including the well-proven E-start; the MDM version with the new active engine protection;
and the COMPATROL® 2.0 version which will offer both compaction control and engine protection.


MDM engine protection


The soil compactors CR 6, CR 7, CR 8 and CR 9 with MDM engine protection and COMPATROL® 2.0 
offer extensive safety precautions. In case of low engine oil pressure, high engine temperature or
heavily soiled air filter, the Hatz diesel engine switches off automatically. If an error occurs, it is signaled
by a LED indicator to the operator. Engine damages caused by inadequate maintenance, belong to the
past.
Life time and operational reliability of the engine are significantly extended.



The green LED indicates that the soil compactor is ready for use.

___________________________________________________________________________________________


Error message: Engine oil pressure is too low! The engine will be switched off immediately.

___________________________________________________________________________________________


Error message: Battery is not charging!

___________________________________________________________________________________________


Error message: Engine temperature too high! Shutdown 3 minutes after the LED has flashed.

___________________________________________________________________________________________


Error message: Air filter very dirty! Shutdown 10 minutes after the LED has flashed.

___________________________________________________________________________________________


Display before next maintenance time.
10 hours before the maintenance time has been reached (first maintenance at 150 operating hours), the LED flashes.
The service date will be displayed for 5 seconds, then switches over to hour meter.
After engine start only the operating hours are displayed.


Further information:

  • Switch off the machine on the ignition lock.

  • Resetting the maintenance time using a magnet.

  • MDM display can be changed (e.g. by external damage).

  • Ignition lock can be changed easily.



COMPATROL®

COMPATROL® is based on a frequency band analysis and consists of a display (CCD Compaction Control Display) and an accelerometer.
COMPATROL® measures the acceleration increase or decrease of the base plate, compares the measuring with the soil conditions registered by the system and convert it to “electrical voltage”. The result is easily shown in the display:
If the number of flashing diodes does not increase, it indicates to the operator that the maximum compaction has been achieved on that soil with this machine.  

COMPATROL® 2.0 – the extension of the compaction control to the active motor protection MDM applies to the soil compactor of the series CR 6 to CR 9.

COMPATROL® is not replacement for conventional testing methods, but provides you an useful addition to the quality assurance.



Automatic function check of the machine.   



        
Automatic  frequency check of the machine.
(Green LED flashes until optimum frequency
is reached).                                                                 



Operation (after 5-10 seconds)

Brochure MDM / CCD 2.0



back